Preparation and Characterization of Antimony Doped Tin Oxide Thin Films Synthesized by Co-Evaporation of Sn and Sb using Plasma Assisted Thermal Evaporation
Electronic Archive of Sumy State University
Переглянути архів Інформація| Поле | Співвідношення | |
| Title |
Preparation and Characterization of Antimony Doped Tin Oxide Thin Films Synthesized by Co-Evaporation of Sn and Sb using Plasma Assisted Thermal Evaporation
|
|
| Creator |
Jariwala, C.
Dhivya, M. Rane, R. Chauhan, N. Rayjada, P.A. Raole, P.M. John, P.I. |
|
| Subject |
Transparent Conducting Oxide
Antimony Doped Tin Oxide Thin Films Co-Evaporations Plasma Assisted Thermal Evaporation Optical Properties X-Ray Diffraction Electrical Properties Scanning Electron Microscopy |
|
| Description |
Tin oxide (SnO2) thin films are having promising properties such as high visible transmittance and low electric resistivity, makes them very important transparent conductor in a variety of optoelectronics devices. Further, doping with pentavalent impurity such as Antimony (Sb) enhances its conductivity considerably. In order to study the effect of Antimony doping, Antimony doped tin oxide (SnO2 : Sb) thin films have been prepared by the co-evaporation of Sn and Sb using Plasma Assisted Thermal Evaporation (PATE) in oxygen (O2) partial pressure at various doping level from 4% to 25%. The influence of various Sb doping levels on the compositional, electrical, optical and structural properties have been investigated using Energy Dispersive X-ray (EDX) spectroscopy, Ultraviolet-Visible (UV-VIS) transmission spectroscopy, four-probe resistivity measurement and X-ray Diffraction (XRD), respectively. EDX studies confirmed the different Sb doping levels in the grown films from 4 % to 25 %, while electrical resistivity is obtained in range of 0.36 to 9.5 Ohmcm using four-probe setup for 4 % to 25 % Sb doping levels. Transmittance spectra measured in UV-VIS range for Sb doped films show reduction in an average transmittance in respect to increase in Sb doping levels in the grown films. Whereas, XRD analysis reveals that higher Sb doping of 25 % induce the precipitation of antimony oxide (Sb2O3) phase and its precipitation suppressed the growth of SnO2 peaks as well as responsible for reduction in conductivity and transparency. The best electrical resistivity of optimized SnO2 : Sb (5 %) is 0.36 Ohmcm without deteriorating the high (~ 80 %) average transmittance in the wavelength region 300-800 nm in comparison to undoped SnO2 film (6.57 Ohmcm) , confirm the usefulness of SnO2 : Sb (5 %) films for device applications.
|
|
| Publisher |
Сумський державний університет
|
|
| Date |
2013-06-19T15:22:19Z
2013-06-19T15:22:19Z 2013 |
|
| Type |
Article
|
|
| Identifier |
C. Jariwala, M. Dhivya, R. Rane, et al., J. Nano- Electron. Phys. 5 No 2, 02029 (2013)
http://essuir.sumdu.edu.ua/handle/123456789/31025 |
|
| Language |
en
|
|