Об установлении интервалов между калибровками средств измерений
Наукові видання Харківського національного університету Повітряних Сил
Переглянути архів ІнформаціяПоле | Співвідношення | |
Title |
Об установлении интервалов между калибровками средств измерений
Про встановлення інтервалів між калібруваннями засобів вимірів About establishment of intervals between calibrations of measuring instruments |
|
Creator |
А.А. Данилов
Д.В. Спутнова Ю.Г. Тюрина О.О. Данилов Д.В. Спутнова Ю.Г. Тюріна A. Danilov D. Sputnova Yu. Tyurina |
|
Subject |
Метрологія, інформаційно-вимірювальні технології та системи
УДК 621.317 интервал между калибровками, калибровка, неопределенность измерений, средства измерений інтервал між калібруваннями, калібрування, невизначеність вимірювань, засоби вимірювань calibration, interval between calibrations, measuring instruments, measurement uncertainty |
|
Description |
Предполагая, что составляющая от нестабильности средства измерений на непродолжительных интервалах времени является линейной функцией времени, а калиброванное средство измерений можно продолжать использовать до тех пор, пока с течением времени (из-за нестабильности средства измерений) расширенная неопределенность измерений не превысит некоторой заранее принятой максимально допустимой неопределенности измерений, установлены соотношения между указанными неопределенностями и интервалом между калибровками средств измерений.
Припускаючи, що складова від нестабільності засобу вимірів на нетривалих інтервалах часу є лінійною функцією часу, а калібрований засіб вимірювань можна продовжувати використовувати до тих пір, поки з плином часу (через нестабільність засобу вимірів) розширена невизначеність вимірювань не перевищить деякої заздалегідь прийнятої максимально допустимої невизначеності вимірювань, встановлені співвідношення між зазначеними невизначеностями і інтервалом між калібруваннями засобів вимірювань. Carrying out calibration of measuring instruments allows to establish a ratio between values of sizes which provide standards, and the corresponding indications of measuring instruments. Considering that measuring instruments have some instability, the question is undoubtedly relevant: how it is long possible to apply the ratio established at calibration between indications of measuring instruments and the corresponding values appropriated to them? Management of ILAC-G24/OIML D 10: 2007 offers 5 methods of definition of intervals between calibrations of measuring instruments. However these methods are only listed in the Guide, but do not open many questions of their practical application. Article purpose – to formulate practical recommendations about establishment of intervals between calibrations of measuring instruments. The methodology of carrying out researches consists in the following. It is supposed that the component from instability of a measuring instrument on short intervals of time is linear function of time with proportionality coefficient. Then the calibrated measuring instrument can continue to be used until eventually (because of instability of a measuring instrument) the expanded measurement uncertainty does not exceed some in advance accepted maximum allowed measurement uncertainty. As a result ratios between the specified uncertainty, the coefficient of proportionality mentioned above and an interval between calibrations of measuring instruments are established. Practical examples of determination of coefficient of a proportionality of linear dependence of the making uncertainty caused by instability of a measuring instrument from time are given. The conclusion is drawn on expediency of application of the offered approach for an establishment of intervals between calibrations of measuring instruments. |
|
Publisher |
Харківський національний університет Повітряних Сил ім. І. Кожедуба
Харьковский национальный университет Воздушных Сил им. И. Кожедуба Kharkiv national Air Force University named after I. Kozhedub |
|
Date |
2018
|
|
Type |
info:eu-repo/semantics/article
info:eu-repo/semantics/publishedVersion Рецензована стаття |
|
Format |
application/pdf
|
|
Identifier |
http://www.hups.mil.gov.ua/periodic-app/article/19094
|
|
Source |
Системи обробки інформації. — 2018. — № 4(155). 98-102
Системы обработки информации. — 2018. — № 4(155). 98-102 Information Processing Systems. — 2018. — № 4(155). 98-102 1681-7710 |
|
Language |
rus
|
|
Relation |
http://www.hups.mil.gov.ua/periodic-app/article/19094/soi_2018_4_15.pdf
|
|